2004-12-07, 08:13 PM
At present I use a PVR350 and use the supplied Hauppauge IR cable to control GBPVR. This then controls USB UIRT to change channel on my STB.
When I used sage I was able to use the USB UIRT to both receive and transmit codes.
I am about to switch to a PVR150MCE this does not have a Hauppauge ir input. Is it therefore possible to use USB UIRT as my remote control receiver as well as transmitter.
Hope that makes sense.
When I used sage I was able to use the USB UIRT to both receive and transmit codes.
I am about to switch to a PVR150MCE this does not have a Hauppauge ir input. Is it therefore possible to use USB UIRT as my remote control receiver as well as transmitter.
Hope that makes sense.
MSI FA-4 speedster, Pentium M 2.0, 2 gig memory ,nvidia 210, Samsung Ecogreen 1.5 Terabyte Hard Drive
