Config crashes when scanning with Nova-T USB2

[dbisqlg]

Hi,

I've seen a lot of threads about config.exe crashing when scanning channels. Sadly no solution has fixed my problems.
I'm using:

GB-PVR v1.3.11 with a Hauppauge Nova SE2 and a Hauppauge Nova-T USB2.
While the SE2 is now working fine the Nova-T crashes config.exe as soon as I click on 'Map digital channels to EPG channels' with an unhandled exception.

When clicking on 'continue' there is a message from config that it was unable to start the DBA device....

WinTV is installed and both tuners (SE2 and Nova-T) are working fine.

Any ideas what might cause this error or maybe a thread about this I haven't sees so far?

Thanks for your help

Oliver

[sub]

Post the config.exe.log and config.exe-native.log and I'll take a look.

[dbisqlg]

Here You are.

Thanks Sub

Oliver

[sub]

2009-01-12 16:06:13.421 VERBOSE FindFilterByName failed to locate filter: Nova-T Stick DVB-T Tuner (Dev1 Path0)

Are you sure you selected the correct device type when you setup your capture source? If so, then run filtercheck.exe and post the filtercheck.log.

[dbisqlg]

Hi Sub,

thanks for the quick reply.
Attached the filter log file.

Thx
Oliver

[sub]

You've got the device number set incorrectly on the Nova-T stick capture source. It should be set to device #1. You have it set to device #2.

You only need to increment the device number when you have multiple devices sharing the same drivers. Your two devices have different drivers so are both device #1.

[dbisqlg]

Arggg. Stupid me. Must have missed that in the documentation.

That did the trick.

Thanks for your help sub.

Oliver