USB-UIRT Remote Control settings for GBPVR

[Gemini1706]

Is there a way to config the settings of USB-UIRT that GB-PVR uses to send channel numbers to the Sat Receiver? Kinda like the SageTV remote ini file, that you can changes the count and timing ...etc.?

I am having trouble letting GBPVR tune to the right channel (it learns fine, but there is no way to TEST the learning) so I make a fake recording and wait for it, then it looks like GB-PVR (or more accurately, USB-UIRT) sends the wrong channel number (I want 1 0 7, it sends 0 0 4 oe soemthing).

I have a more lengthy question related to this in the USB-UIRT forums if you wan to refer to it:
http://166.70.183.44/phpBB2/viewtopic.php?t=381
It has other issues not related to GB-PVR.

Is it the placement of my receiever?

I used to have GB-PVR version 205, and it was working fine. But I needed to r-install wondows and eveything, and now isntalled the latest GB-PVR (ver 214 I beleive?), and things look a little different now

Is it something from GB-PVR (new version)? Or USB-UIRT? Or Girder?

I think the channel numbers are GB-PVR issue (AND USBUIRT) so it would be nice to know if I can edit some file to cofnig the USB-UIRT behavior...

When it is about time to enjoy my first HTPC, now I have huge remote control problems..

Thanks in advance...

[sub]

You can add the two following lines to your USB-UIRT IR file:
<table border="0" align="center" width="95%" cellpadding="0" cellspacing="0"><tr><td>Code Sample </td></tr><tr><td id="CODE">InterCodeDelay 200
RepeatCount 4[/QUOTE]
The numbers above are the defaults.

[Gemini1706]

Issue resolved.
The problem was I edited the 'Channel Source' numbers in the capture source thinking those will affect the ordering of channels listed in GBPVR, it turns out that those are the actual numbers that are used by GBPVR to send the code to the Sat receiver Now I put the old numbers back, and eveything is working fine
(By the way, the other issue I had with USB-UIRT as described in my thread in the USB-UIRT forum is not related to the cable length, but more to the code of learnt, and this is now also resolved)..

Thanks sub for help

Cheers...