Capture resolutions

[d3cadent]

Hi,

I am using an analogue capture card (WinFast PVR2000). When I set it as a capture device, I can only specify a limited set of screen resolutions to use, the highest of which is NTSC 720x480 / PAL 720x576. I would like to use the highest resolution available on my card, which is 768x576. Is there a way I can access that mode?

Thanks,

Tom

[sub]

Sorry, I dont think its able to change the resolution at all on a WinFast PVR2000. Most manufacturers use their own proprietary mechanisms for changing resolutions. GB-PVR supports a couple of common manufacturer's methods (Hauppauge, Adaptec, YUAN). Recordings on other card will just get the default resolution for that card.

The default will probably be the full PAL resolution though.