HVR-1950 not listed when attempting to set capture source

[npark]

Hello,
I've purchased a Hauppaugge HVR-1950 and I've installed GBPVR 1.2.13 on a laptop with 1.5ghz core2duo, 1.5gb ram, running Vista. In Config, when I'm attempting to set the capture source, I don't see the HVR-1950 listed as one of the devices.

After a quick search, I found this post: http://forums.nextpvr.com/showthread.php?p=286729

So I added the following to my direct.ini
[Hauppauge HVR-1950]
INIT_MODE=ECP
INIT_MSP=0
SUPPORTS_FM_RADIO=0
BLACKBIRD=1
CONEXANT=1
FILTER_CROSSBAR=Hauppauge HVR USB2 Crossbar
FILTER_CAPTURE=Hauppauge HVR USB2 Video Capture
FILTER_TV_TUNER=Hauppauge HVR USB2 Tuner
FILTER_TV_AUDIO=Hauppauge HVR USB2 TvAudio
FILTER_ENCODER=Hauppauge HVR USB2 MPEG Encoder
PIN_CROSSBAR_VIDEO_TUNER_IN=Video Tuner In
PIN_CROSSBAR_AUDIO_TUNER_IN=Audio Tuner In
PIN_CROSSBAR_VIDEO_DECODER_OUT=Video Decoder Out
PIN_CROSSBAR_AUDIO_DECODER_OUT=Audio Decoder Out
PIN_TVTUNER_ANALOG_VIDEO_OUT=Analog Video
PIN_TVTUNER_ANALOG_AUDIO_OUT=Analog Audio
PIN_TVAUDIO_TV_AUDIO_IN=TVAudio In
PIN_TVAUDIO_TV_AUDIO_OUT=TVAudio Out
PIN_CAPTURE_ANALOG_VIDEO_IN=Analog Video In
PIN_CAPTURE_ANALOG_AUDIO_IN=Analog Audio In
PIN_CAPTURE_I2S_OUT=I2S
PIN_CAPTURE_656_OUT=656
PIN_ENCODER_I2S_IN=I2S
PIN_ENCODER_656_IN=656
PIN_ENCODER_OUT=MPEG
PIN_WRITER_INPUT_IN=Input

So after that change, when I attempt to add a capture source and I select the Capture Card Type and use the checkbox to Show Devices installed on this machine, I see the HVR-1950 listed. I set this up with the Composite setting (there are 3, I tried all three). I have the HVR-1950 connected via composite to my STB.

However, after selecting that type I don't see to have success with getting LiveTV to work. Rightclicking on the system tray icon for gbpvr and then going to status show the capture sources as "sleeping".

I know the device works as it seems to be fine with WinTV.

Any suggestions would be greatly appreciated.

[sub]

2008-09-26 02:31:56.065 VERBOSE [1] GBPVR.Backend.Common.GbpvrException: No channels have been set up. Please run the Configuration utility and setup the EPG source. Use the 'Update EPG' button to force the system to import the latest set of channel and programme information.

You havnt setup the EPG on your capture source.

[npark]

Hi sub,

Thanks for the quick response. I setup the EPG but I was still out of luck. It turns out that I had some .net issues and I had to uninstall and update some things.

Now, LiveTV is working! Thanks for the awesome product.