Web service says request can't be processed

[Warwick]

Love to get this running on my PCH but not off to a good start.

Installed mvpmcx 2.2.2 via CSI and that reports it installed and started.

Been running GBPVR for a while so ran NMTinstall without GBPVR selected, added in the 4 June updates. Checked GBPVR still runs fine on PC - all ok

Select MVPMCX from PCH webservices menu and get " request can't be processed"

Checked out connectivity and PCH samba browser can see and browse mvpmc share back on the PC. Turned off the Windows7 firewall but that didn't make any difference. With windows7 I have needed to open a port to get other stuff running - is there a port that I need to open to get MVPmcx2 to talk to the PCH?

How do I generate a log to check out what is happening here?

[mvallevand]

The elegance of the CSI solution is that it doesn't require the mpvmc share or any Samba networking to start up GBPVR. Off hand the only thing I can think of is that you did not configure the hardware type properly in CSI. When it starts up check Extra->Settings and the Hardware Type should normally be "All Others" unless you have a B110 or possibly some alternate device.

I know CSI needs to talk to the PCH on port 8883 but it sounds like you got further than this. I am not a CSI expert, I suggest you post this question on the NMT forums, where Ger Teunis should be able to help and I'll try and follow the thread, if he needs some mvpmcx2 information.

This is an internal problem like file not found which is pretty basic extra logging won't help. If it was a firewall, connection, or configuration issue you'd get a black screen. I can help with those if you get to that point.

Martin.