Transcode/Auto Convert

[bgowland]

"CyberLink MPEG Muxer" is the human readable name which is registered when you use regsvr32 to register the mux.

Both MpgMux.ax and THMpgMux.ax will probably register that name.

Cheers,
Brian

[philip1982]

I now have this:

GB-PVR has detected the following multiplex filters on your machine:

Found: CyberLink MPEG Muxer
FILE: C:\Documents and Settings\Philip\My Documents\Downloads\gbpvr\cyberlink mux\THMpgMux.ax
VERSION: 5.0.1307



If you're running WinXP SP1 or higher, you will also be able to use the built-in DVR-MS mux filter

Still can't get transcode to work, or does GBPVR auto convert.....???

[sub]

Can you post another set of logs now that you've got that mux filter?

[philip1982]

logs enclosed - are they the right ones???

[philip1982]

Hi Sub - did you managed to look at these logs?

[sub]

Unfortunately there isnt enough logging around that operation so I cant tell the cause. I've added a couple more messages for the next release that should tell me why its not working for you.

I have double checked the code though. The logic has two checks - if (1) the "CyberLink MPEG Muxer" filter is on your machine and (2) the file extension is ".dvr-ms", so as long as both of those conditionals are true then it should show the pop popup.

[philip1982]

OK - I've just had another look.

The Transcode box pops up on an MPEG recording I have, but not on the DVRMS recording I want to transcode.

[fluffykeith]

I think you only need to install one, the THMPGMux seems to be best (at least for me) and I guess you have to select it in the config too.

[philip1982]

I've got that one installed. But neither the auto-transcode - or manual are working.

[sub]

Ok, we'll look into it when the next release is out in a couple of weeks.