Hauppauge 45-button remote stopped working

[h00ch]

Well, I tried pointing the remote at my digital camera and sure enough I could "see the light", so it's not the remote that's pooched.

I finally gave in and installed everything in my other computer upstairs and everything worked as expected (yes, even the remote!). So back downstairs I went to the PVR PC. I was about to put it back in the same PCI slot as before, then I thought I'd install it in a different slot, because I was at a loss for other things to try.

IT WORKED! Something happened to my original PCI slot, to cause the IR receiver to stop working. Could it possibly be some sort of IRQ conflict even though the rest of the PVR card works like it's supposed to?

Anyways guys, thanks for all your great help and tips. It was all very much appreciated!

cheers,
Dave

[GoodGuys]

Could it possibly be some sort of IRQ conflict even though the rest of the PVR card works like it's supposed to?

Sure.

Anyways guys, thanks for all your great help and tips. It was all very much appreciated!

You're welcome.

GGF

[HtV]

I don't know - the Receiver shouldn't be "lighting up" in any way.
The Receiver is just a receiver, it shouldn't be emitting any light...
Unless I failed to understand what you mean.
In the 150, the only thing that could light up is the IR blaster, which is on a very thin cord. The receiver is on the thicker cord.
GGF

I did't mean the hauppauge receiver but the light/receiver in a tv or mvp e.g. They do flash alittle when they receive a signal.