Remote not working 100%

[pcostanza]

After installation of 90.10, my Hauppauge remote only does a few things. It will not control the main menu unless I hit 'ok'. Won't go up or down. The TV Guide only goes up or down 5 channels at a time but again, not left and right. Checked the settings and they are the same as always.
Tried the remote that comes with the MediaMVP and it reacts the same.
Any suggestions?
Thanks

[darrin75]

Try this, mine get that way sometimes, stop the mvpserver from gbpvr, press the power button on the remote, to turn off power to the mvp, (don't mistake this for unplugging it) so don't unplug it. Restart go to config and you don't have to change anything just hit ok, that should restart gbpvr, restart mvpserver and then press power button on the mvp remote. This Always works for me..

[pcostanza]

Darrin, thanks but, unless I did something wrong, it didn't work for me.
When you say 'stop the mvpserver from gbpvr' you do mean in the configuration/mvp playback? The remote works fine for use on the MVP but it's the remote I use on my pc to operate gbpvr......I don't have it set to tv out but for playback on the pc.
Thanks for your reply.

[sub]

I know what the problem is. I'll post note about how to fix it in a minute.

[pcostanza]

Thanks sub, the fix worked perfectly. Ran thru everything to see what the bugger was happening and thought my remote was dying.
Nice, fast work.

Paul

[arunag]

Sub, I am having the same problem how did you go about fixing the problem

Arunag

[sub]

I posted the fix instructions in the v0.90.10 announcement thread.