EPG Problems

[Gareth2061]

I get no EPG info either. Im in the Uk and using the freeview EPG. When I click EPG it says it updating the info, then dissapears after 5 seconds. I dont think its even doing anything.

[sub]

Hit the 'Update EPG' in the capture source settings, then zip and attach the config.exe.log and config.exe-native.log and I'll take a look.

[Gareth2061]

Done, thanks.

[sub]

You currently have your recording directory set to C:\Temp. Does that directory exist?

[Barsk]

I figured out why I did not get the updated EPG data. Actually I did, but it took several minutes for the process to complete. And it was done silently in the background. I used the update menu item in the tray.
As I can remember we got a status window popup previously that displayed the message Updating EPG or something during the process. Nowadays I get nothing in the status window, it actually says idle for all tuners although the update is in progress in the background. If I get into the TV Guide in this state I get nothing in the EPG data. If I wait until it is completed I get the updated data.

If I run the EPG update from inside the System plugin, I get status messages in a correct manner. Seems like a little bug here... ;-)

I have XML TV data, and three tuners if that has someting to do with it.

[Gareth2061]

Ahh thanks, changed the dir and it actually went through the scanning process. Still no EPG info showing though. I attatched new logs this time.

[sub]

Ahh thanks, changed the dir and it actually went through the scanning process. Still no EPG info showing though. I attatched new logs this time.

In this case it never managed to start the device. Are you sure the device wasnt in use elsewhere in the system?

2008-03-27 10:39:28.765 ERROR Failed to start BDA Graph
2008-03-27 10:39:28.765 VERBOSE ERROR_GEN_FAILURE

[Gareth2061]

By device do you mean my TV card? It wasnt in use anywhere.

[sub]

Yes, I meant the device. Sorry, I'm not sure then.

[paf077]

I get the same "no show details" and all the shows are excatly 0ne hour long. so there's something messing with the xmltv file and not reading it right. I emailed shcedules direct and they said the datya was sent correctly, so the problem is with the aprser in GBPvr. Im still using ver 1.1.5 and changed
absolutely nothing. I will only install ver 1.2.9 when this is resolved. This seems to be quite wide ranging.
I have tried to clear everything in the epg et reload but it still
does the same.

Any chance this as anything to do with the daylight savings time that came in to effect 2 weeks ago, 3 weeks earlier then before?
Just asking because my epg is set for 14 days and it ran out tuesday at 2300 hrs.