Recording wrong channel!

[Satfinder]

I was hoping my experience might help with Danny's problem but I'll not say no to an assist with my own one. What I did to generate the attached logs was:
1) Ran config and
a) Removed all but one capture source (DVB-S)
b) Removed all but two channels
2) deleted log, reran config to generate a clean log
3) Went into Live TV for 2nd channel (BBC 2)
4) Pressed pause - screen went blank this time - then pressed X
5) Exited PVRX2.
I think all the config.xml settings are unchanged from the installed version.

If I've overdone my attempt to keep the zip file small, let me know.

Thanks!

[sub]

2008-07-07 21:41:27.170 VERBOSE FindFilterByName failed to locate filter: GB-PVR PSI Parser

Can you try running reregisterfilters.bat, then enable log flushing and try reproducing the error. If it still has problems, zip and attach the logs again and I'll take a look.

What mux option do you use?

[Satfinder]

Same outcome after reregistering the ax files. Was using "Full TS" setting for BDA mux. Attached are the relevant log files.

[sub]

Ah - you shouldnt be using the 'Full TS' option. This causes all the channels on that frequency to be recorded. This option is only intended to be used for people producing debug files for me. When you play back the file in GB-PVR it'll always show you the first channel.

You should be using one of the other mux options.

[Satfinder]

Problem sorted! Thanks for your help. Maybe this is Danny's problem too?

[sub]

Maybe. He didnt post any logs, so we'll have to wait until he responds.

[Dan_HTPC]

Thanks guys...

Sorry, just logged on again this evening to find all the replies. I tried recording TV6, and sure enough, it started recorded TV1. I check my BDA Mux setting, and it was Full TS (don't remember changing that but I probably did!). Now the recording problems seem to be fixed!!

Right, now to try and get playback through GBPVR smoother. My recorded files play smoothly through Powercinema or WMP - I'll do a bit more digging, and if I'm still stuck I'll post another support question.

Again, thanks for your help!
Danny