GBPVR Recording Service Crashing

[onestar]

Hi,

I couldn't get channel service.exe working, so scanning through, I enabled "allow service to interact with desktop".

I setup a test recording and sure enough the channel changer works. But almost immediately after the service crashes.

Any ideas? If I disable allow interact, it doesn't crash (but doesn't change either)

I ran the cmd.exe as well as this.

cc.cmd {channel}

The logs end of the log is
2008-10-12 09:06:40.625 VERBOSE [5] Changing to channel (GBPVR.Backend.Common.ExeChannelChanger): 608
2008-10-12 09:06:40.625 VERBOSE [5] Running: o:\windows\system32\cmd.exe /c i:\redrat\RR_CLI\cc.cmd 608 plus
2008-10-12 09:06:40.640 VERBOSE [5] Requesting IRecordingSource to start recording: L:\mediacenter\record\Manual Recordings\test_2008$
2008-10-12 09:06:40.656 VERBOSE [5] DirectRecordingSource about to start recording oid:1 channel:608


And then it ends.


Any hints please?

Thanks

[gEd]

http://forums.nextpvr.com/showthread.php?t=35529

you need the patch from post #7

[onestar]

thanks, just tried that, but no change.

In the event log there is an error
GBPVRRecordingService.exe version 1.0.3069.9824, faulting module WSTSRTAnalog.ax version 0.1.0.0 fault address 0x000b7a2

[onestar]

Okay I should add a minor update. With or without interact with desktop it crashes. I've only had a success recording once this morning (without channel change). Since then it appears to crash always starting a recording now

[onestar]

Okay forget it....... ran out of space. Opening a new thread for new question.