Is there a way to force PVRX2 to use exisitng graph?

[sub]

Sorry, no I didnt. I'm out of the country for the next couple of weeks, so away from my development/test machines.

[jezz2020]

no worries sub, i will raise again in a few weeks if needed, thanks

[scim]

I suspect this issue may be pretty common but since it is intermittant and presumably if you have good reception very intermittant it may not be reported much. I can confirm that I have exactly these symptoms, again they appear on some channels that are running on reduced power.

[jezz2020]

bump

any further suggestions on what i could try / change etc?

Given my stable reception for tv3 (transmitted on same frequ as C4) I have excluded reception issues as the cause of my problem, am at a total loss!

[serafis]

Similar symptoms here. TV1,2,3,6,7 etc fine on DVB-T but C4 freezes, hops skips and jumps all over the place in either Live TV or recorded. After a few minutes playing C4 on Live TV, the picture will usually freeze completely but the audio carries on.... until I change the channel or exit. Recordings are pretty much unwatchable.

(Incidentally, Freeview|HD does much the same, but not so badly or frequently, and there's not much to watch on that anyway)!

Using a HVR900 USB stick with external antenna, Cyberlink PDV7 H.264 and Monogram AAC decoder.

Any suggestions for improvement much appreciated - at the moment I have to use C4 from Analog instead.

[sub]

I'm back in NZ now, but a bit busy with work today. If someone bumps the thread tomorrow, I'll check it.

[jezz2020]

I'm back in NZ now, but a bit busy with work today. If someone bumps the thread tomorrow, I'll check it.

bump

[mikenkylie]

I have the same problem with DVB-T but C4 freezing, skipping and jumpping all over the place in either Live TV or recorded.
any help would be great thanks.

[mikenkylie]

bump

[scim]

bump