2005-08-08, 01:07 PM
Bear with me I'm doing this from memory as I'm waiting for Broadband at my new abode.
Have run GB-PVR config a few times trying to get DVB-T channels in a a couple of poor reception areas. Had it prompt me for some mpeg code that ships with Showshifter and fail to start my card (and then crash) when I've misconfigured. But eventually I worked it out and got it up and running to discover the reception at these locations was too poor.
Now I'm settled I've come to set it up and I went and chose the wrong Nova-T model and it crashed when mapping channels to epg entries (after telling me it failed to start the BDA drivers for the card). After the crash and choosing the correct Nova-T model in the BDA driver config it now asks me to find the configuration folder when I map the channels. Then if I navigate into a drive it just hangs offering me none of the folders therein.
An uninstall (with manual folder delete to eliminate and corrupt config stuff remaining) and reinstall results in the same situation. Any clues?
Have run GB-PVR config a few times trying to get DVB-T channels in a a couple of poor reception areas. Had it prompt me for some mpeg code that ships with Showshifter and fail to start my card (and then crash) when I've misconfigured. But eventually I worked it out and got it up and running to discover the reception at these locations was too poor.
Now I'm settled I've come to set it up and I went and chose the wrong Nova-T model and it crashed when mapping channels to epg entries (after telling me it failed to start the BDA drivers for the card). After the crash and choosing the correct Nova-T model in the BDA driver config it now asks me to find the configuration folder when I map the channels. Then if I navigate into a drive it just hangs offering me none of the folders therein.
An uninstall (with manual folder delete to eliminate and corrupt config stuff remaining) and reinstall results in the same situation. Any clues?
