Changing Quality Profile Settings after 1st Setup?

[jksmurf]

I have a couple of Q's wrt the Config Setup for Quality Profiles

1. Is it by design that the Quality Profile Settings cannot be changed from e.g. Medium Quality to LiveTV Profile after the 1st Setup?

In config, when I select any profile other than medium and click OK, OK and restart the recording Service, then go back into config it has changed back to medium quality.

I can change the settings WITHIN the medium quality e.g. MPEG4 to MPEG2, but it won't save any selection of a new profile. Can this ONLY be set up on first configuration?

2. For each device, is it by design that if you change the setting within the profile for one source within that device (e.g. antenna) e.g. MPEG4 to MPEG2, that this setting is automatically applied to the second source (e.g. S-Video) for that same device, as this is what I am seeing when I change the setting.
Cheers,
k.

[sub]

1. Is it by design that the Quality Profile Settings cannot be changed from e.g. Medium Quality to LiveTV Profile after the 1st Setup?

In config, when I select any profile other than medium and click OK, OK and restart the recording Service, then go back into config it has changed back to medium quality.

Yes, this is by design. "medium" is always the default for a "quick record". In hindsight I should have called it "default".

2. For each device, is it by design that if you change the setting within the profile for one source within that device (e.g. antenna) e.g. MPEG4 to MPEG2, that this setting is automatically applied to the second source (e.g. S-Video) for that same device, as this is what I am seeing when I change the setting.

Yes, this is also by design. There is only one set of settings for each profile across all capture sources, for each of the two families of analog devices (DirectRecording/GO7007SB). Otherwise it was too confusing for the user.