Tuning with Divco card - Fusion Tv Works great - no other package gets signal

[Spooty]

Hi Peoples',

I have been having a great deal of 'fun' with getting signals with my Divco DVB-T-Plus. I recently bought two cards to work with. Currently they are in Different machines as - One with XP Pro and one with XP Media Centre.

I have the same issue on Both machines, it scans all channels and works great with Fusion HDTV. But no other package will scan channels, though Media Centre, picks up a couple of channels. Gb-Pvr None, and Media Portal None.

Things I have tried - Updating the drivers to 3.3, turning off the task agent. I have gone through the forums and tried a few edits of the config file. I noted there was a post with somthing similar, but nothing was resolved.

Any other suggestions greatly appreciated

[Spooty]

Must say at this point ,I am getting kinda annoyed, with my own lack of progress. I have tried to address the issue at the Dvico website.

There was one FAQ that refered to thier FusionHDTV not being able to the same thing in reverse with WMC taking up the DVB and was (supposively) fixed in the 3.01 beta and II have downloaded the stable 3.1 drivers. I have switched to the DVB stated was available by the mux programme. But to no avail.

Windoze Media centre - takes a long time to scan, its been over an our now and only at 5%, I doubt it is going to be sucessfull.

Again, any thoughts to attack the problem from a different dirrection appreciated

Later
Spooty