Postprocessing.bat half works

[reboot]

Having multiple tuners, I would expect postprocessing.bat to run on all recordings...however.
When I have recordingst that end at the same time, sometimes they will get processed, and other times, only one of the two (or 3 or 4) will.
There doesn't seem to be any pattern.
Can I do anything to insure that my full postprocessing.bat get's run on all recordings?

[sub]

postprocessing.bat will be run on all recordings, but only one recording at a time, so if you have multiple recordings finishing at the same time, they processed one after the other.

[reboot]

But this only happens some times. It's not consistent, and I can't figure out why not

[sub]

Nothing has changed in the post processing for several releases. I would have thought we'd have heard more about it if there was a problem.

[reboot]

Maybe it's my mix of tuners, and/or simultaneous shows.
It's actually been an ongoing problem of mine for quite some time, and I've always just manually done what I needed.
I was kinda hoping the teething pains of the latest release had died down enough, and you'd have a suggestion or two.

After further testing, it seems that if the GUI is open, things don't work, only the first recording is processed. If I close it, then everything works properly, but I can't reproduce it 100%.
I'll do more testing, and see if there's any real pattern.

Edit: another thought. If I move part of my postprocessing over to concurrent processing (or whatever that's called, I keep forgetting), I may have better luck.

[sub]

Why dont you put a command like the following as your very first line of PostProcessing.bat:

Code:

echo %1 >> processing.log

This will show you what files PostProcessing.bat is being run against.

[reboot]

Done. We'll see if I can spot any obvious trouble.
thanks once again for making this the best PVR there is