2007-01-28, 09:08 AM
gbpvr 98.14b.
I've added a capture source (DVICO DVB-T) and I've mapped all available channels to my guide. No problems.
But for some strange reason gbpvr will not display one of the channels (this channel is found during the tuning of the capture source).
When I select that channel from the guide and choose watch, I get a unable to tune warning, the two graphs show 0 signal quality, and full signal strength.
The log file shows strength=41000.
I get the same strength and quality figures for a channel that does tune correctly.
See the attached zip file for the gbpvr.exe-native.logs for a tuning to the bad channel and a tuning to a good channel.
Wierdly this channel used to tune fine, plenty of signal as the signal that runs to the back of the PC is from a splitter that also runs to the TV, no probelms with that digital channel on TV.
Any suggestions appreciated.
Thanks,
Greg
I've added a capture source (DVICO DVB-T) and I've mapped all available channels to my guide. No problems.
But for some strange reason gbpvr will not display one of the channels (this channel is found during the tuning of the capture source).
When I select that channel from the guide and choose watch, I get a unable to tune warning, the two graphs show 0 signal quality, and full signal strength.
The log file shows strength=41000.
I get the same strength and quality figures for a channel that does tune correctly.
See the attached zip file for the gbpvr.exe-native.logs for a tuning to the bad channel and a tuning to a good channel.
Wierdly this channel used to tune fine, plenty of signal as the signal that runs to the back of the PC is from a splitter that also runs to the TV, no probelms with that digital channel on TV.
Any suggestions appreciated.
Thanks,
Greg