2008-05-27, 03:52 PM
Hi all - excuse the newbie questions.
I have a PCH A-100 with latest stable firmware and my server is a Windows Home Server (currently not firewalled)
I have installed latest GBVPR, all necessary patches and config.xml changes and installed scripts and mvpmcx2 on the appropriate share. PCH can run telnet script successfully - I can telnet into the PCH without problems. But when I select the gbpvr script I get a blank screen and no remote keys will recover the PCH menus - I have to unlug/replug the PCH power lead.
I have noticed that your survival guide says that PVXR2.exe should be in the firewall exceptions (does not apply to me as I have firewall disabled). However because my WHS is headless it has only basic onboard Intel 945GC graphics and does not therefore have the VMR9 renderer. So to test GBPVR on my WHS I usually run GBPVR.exe (old interface). Could this be the cause of my problems?
Thanks
Richard
I have a PCH A-100 with latest stable firmware and my server is a Windows Home Server (currently not firewalled)
I have installed latest GBVPR, all necessary patches and config.xml changes and installed scripts and mvpmcx2 on the appropriate share. PCH can run telnet script successfully - I can telnet into the PCH without problems. But when I select the gbpvr script I get a blank screen and no remote keys will recover the PCH menus - I have to unlug/replug the PCH power lead.
I have noticed that your survival guide says that PVXR2.exe should be in the firewall exceptions (does not apply to me as I have firewall disabled). However because my WHS is headless it has only basic onboard Intel 945GC graphics and does not therefore have the VMR9 renderer. So to test GBPVR on my WHS I usually run GBPVR.exe (old interface). Could this be the cause of my problems?
Thanks
Richard