2009-03-10, 04:12 AM
Hey, I have the HVR-2250 MCE-Kit that comes with an IR Receiver and 2 IR Blasters. I have Vista Ultimate 64-bit. I have used this in VMC with no problem.
Here is my setup:
I have 2 Set-top boxes which are connected to the HVR-2250 card by s-video (for video) and composite (for audio). I have a receiver connected via USB to the PC. The two IR blasters are plugged into the receiver and are on the front of each set-top box (to send the IR signal to the boxes). This setup works fine in VMC (channels are changed in set-top boxes correctly), but I tried using it in GBPVR and have had limited success. I can navigate the menus and everything, but the channels on my set top boxes (2 of them) do not change.
HIP doesn't work (it crashes when I try to start it) and I haven't had much success with either IRServer or EventGhost.
I installed the MCE replacement drivers, but that didn't work either. The closest I got was IRServer recognizing my IR receiver, but when I tried to learn commands, it would say "Learn IR Failed".
Has anyone gotten this to work with the Hauppauge MCE remote (specifically the one packaged with the HVR-2250)?
I'm at a standstill and am open to suggestions. If anyone has gotten this to work, I would greatly appreciate a detailed explanation.
I feel like I've tried everything, and nothing has seemed to work.
Thanks.
Here is my setup:
I have 2 Set-top boxes which are connected to the HVR-2250 card by s-video (for video) and composite (for audio). I have a receiver connected via USB to the PC. The two IR blasters are plugged into the receiver and are on the front of each set-top box (to send the IR signal to the boxes). This setup works fine in VMC (channels are changed in set-top boxes correctly), but I tried using it in GBPVR and have had limited success. I can navigate the menus and everything, but the channels on my set top boxes (2 of them) do not change.
HIP doesn't work (it crashes when I try to start it) and I haven't had much success with either IRServer or EventGhost.
I installed the MCE replacement drivers, but that didn't work either. The closest I got was IRServer recognizing my IR receiver, but when I tried to learn commands, it would say "Learn IR Failed".
Has anyone gotten this to work with the Hauppauge MCE remote (specifically the one packaged with the HVR-2250)?
I'm at a standstill and am open to suggestions. If anyone has gotten this to work, I would greatly appreciate a detailed explanation.
I feel like I've tried everything, and nothing has seemed to work.
Thanks.
