Problems PVR-350 and PVR-150MCE (v227)

[Edwin10]

My bad. I read a couple of weeks ago that you weren't gonna fix it in the next release. So I didn't check it thouroughly. I'll check tonight.

[rowyourboot]

I have nearly the same combination running, my only problem is the remote from the PVR350.
You can find my exact configuration at: www.pvrstat.de

[Edwin10]

@ rowyourboat

I'm also running the Pundit-R in combination with the PVR-350 and a PVR-150 MCE. Remote on the PVR-350 is working like a charm. What is the problem with your remote ?

I'm also using a Megavideo55 from Marmitek to transport the GUI and sound to other TV's in my house. Works fine and the response is a quite bit faster than the Media MVP.

I'm also running 09.08, and I'll try to enable the PVR-150 tonight to check if they will work together.

[Edwin10]

Allright then. I enabled the PVR-150 MCE in GB-PVR and after some fiddling, it works !!! :-)

The bad news, however, is that the remote doesn't work anymore. It did work on version 0908 without the PVR-150MCE enabled.

I get an error "failed to initialise Infrared Remote hardware"

Direct access to the remote is disabled.
Anyway to get the remote to work with both cards enabled

As an alternative, I have an Irman IR receiver lying around somewhere. Before I start looking for it, is it supported in GB-PVR

[sub]

Quote[/b] ]I get an error "failed to initialise Infrared Remote hardware"

Direct access to the remote is disabled.
Anyway to get the remote to work with both cards enabled

As long as the Hauppauge software is giving you the "failed to initialise Infrared Remote hardware" message, it doesnt matter what settings you choose in GB-PVR, the remote wont work. You really need get the remote working with the Hauppauge software before trying GB-PVR.

This specific error seems quite common for people adding a PVR150/500 to a machine with an older card. There has been some discussion about the problem on http://www.shspvr.com/forum

I think reinstalling the devices & drivers, with the device having the IR hardware installed last, has helped some people.

[rowyourboot]

At this topic you can find a solution running to the next reboot

http://www.shspvr.com/forum....0%20150