Config loses Capture Source

[daveatk]

Every time I enter Config, the Capture Source is empty since I switched v0.97.9 The logs are attached. There may also be recording issues, but I just swicthed to SQLite. Not sure if that is linked or a separate issue.

[sub]

7/3/2006 8:39:09 AM.218 ERROR [1] Encountered an error trying to upgrade the existing database: The process cannot access the file because it is being used by another process.

Its something to do with this error when GB-PVR tried to access its database (GBPVR.MDB). You didnt have the database open in Microsoft Access? Did you try rebooting?

[daveatk]

I've rebooted a few times. I've reloaded the configurations from Zap2it a number of times. I switched to the SQLite. Everytime I enter Config, it shows no capture sources. I have not power cycled if you think that would change something?

[sub]

Post the logs again, and I'll see if you're still getting the same error.

[daveatk]

Here are fresh logs. Still no luck

[sub]

Try stopping any GBPVR software, including the recording service, then delete GBPVR.MDB and gbpvr.mdb.original if you have it. Then try again.

[daveatk]

I copied then delete the 2 MDB files. I then went in and configured the zap2it setup. Then I exited config and re-entered a few times. The configuration stayed there. I've since re-entered my recording wishes. This also speeded up the initial start up of GBPVR program.

Thanks