Launching PVRX2 with HIP / MCE Remote

[petewxm]

when in the config screen press "ctrl P" and it will bring the preference screen up , or you could use the drop down menu in the config screen, "file/preferences"

Hope that helps

Pete

[mobiusnz]

Ok - no got for me, as I said - when I test it it always works. When the wireless keyboard is sitting back where it belongs and I'm spread out on the couch - it fails! I can't say I can see ANY difference at all running with or without the -fse switch. I've got "WindowsForms10.Window.8.app.0.378734a" in the Window class name but that never made any difference. Its like with the lag of starting something else takes the fore?

[stustunz]

the fse has to be be put in the application properties of hip

so under alternate input
add the start key for pvrx2
add exucute program
parameters >-fse

if you only direct it to a short cut with the fse added it doesnt start in fse

i just have it set to send to last selected app then the red button on my remote is the hip control key so if it does lose focus for what ever reason i an get it back

[zehd]

Ok - no got for me, as I said - when I test it it always works. When the wireless keyboard is sitting back where it belongs and I'm spread out on the couch - it fails! I can't say I can see ANY difference at all running with or without the -fse switch. I've got "WindowsForms10.Window.8.app.0.378734a" in the Window class name but that never made any difference. Its like with the lag of starting something else takes the fore?

I also can't get away from that problem.

Seriously, try MVPServerChecker. It's a small program that doesn't hog any resources.

Whenever either GB-PVR or PVRX2 loses focus or is resized, it pops it to maximized and foreground.

[djmuk]

As I said it works perfectly for me using run/show - if it isn't running HIP starts it, if it is then HIP gives it focus....

File / preferences, Alternate input tab, add the green key to the defined list with run/show GBPVR/PVRX2...

[mobiusnz]

As I said it works perfectly for me using run/show - if it isn't running HIP starts it, if it is then HIP gives it focus....

File / preferences, Alternate input tab, add the green key to the defined list with run/show GBPVR/PVRX2...

Ok - I did have the -fse in the parameters of Program 1 but it was almost as if it was being ignored - Now I've added it to the Alternate Input section as well so I'll let you know if this does it!

Matt

[stustunz]

make sure the -fse is in parameters in alternate input
not on the end of the short cut

[shrek]

make sure the -fse is in parameters in alternate input
not on the end of the short cut

Yep, I discovered this yesterday

[mobiusnz]

make sure the -fse is in parameters in alternate input
not on the end of the short cut

Ok - so far so good - by putting the -fse in the alternate input rather than the Program 1 section of HIP it looks like its all go - I haven't used it extensively but every time so far its been good!

Thanks everyone!

[stustunz]

i have my back up incase it does lose focus which i mentioned in a previous post(red button programed )
it seems in pvrx2 to sometimes happen i never noticed that in the old version but couldnt be sure anything has changed rosie coloured glasses when it comes to 99.12