2007-02-09, 04:43 PM
Quote:Before I upgraded to .99 I had a blastcfg file, however after I upgraded there is no blastcfg file. Do I need to re-run the Hauppauge IR config?BlastCfg is Hauppauge software, in the Hauppauge directories somewhere else on your hard drive. It absolutely would not have been removed when you upgraded GB-PVR.
Quote:When I ran it the first time I could never get it to work the blaster light would blink but nothing happened to the satellite receiver (it didn't go on or off). I ran through all the codes to test it and none seemed to affect the box. I am running a directv d10 receiver. I haven't gotten a chance to tinker with it last night so I will look at it tonight i hope to get it working. I think this is the last "big step" to getting it all workingSorry, I cant help you with that one. As I said, I didnt write the BlastCfg utility. Someone else here that has this same directv receiver might be able to advise you further though.
