Loose a capture card after reboot?!?!

[sub]

I'm not really sure. Does mytheatre work with that device immediately after booting?

I didnt see your previous reply when I typed that.

[psycik]

You saw the reply about the mytheatre?? Yes it does go (no picture though - but it's been like that a while).

I've tried disabling a card and now rebooting, if that doesn't work I'll take one of them out..

[sub]

You saw the reply about the mytheatre??

Yeah, but not until I'd typed the question to try it.

I dont really know. Are you positive mytheatre isnt holding on to the device at boot up?

What do you normally do to get it working after this problem?

[psycik]

Yeah, but not until I'd typed the question to try it.

I dont really know. Are you positive mytheatre isnt holding on to the device at boot up?

What do you normally do to get it working after this problem?

MyTheatre shouldn't be holding anything now, as it's gone. But removing that and rebooting made no difference.

Have disabled one of the cards and rebooted, and now it works again.

I had the second card in there a while, but never loaded the drivers. Guess this was the first reboot after loading the drivers. What i had to do somethime then, was reimage my machine to before i put the drivers of the second card in.

But for some reason doesn't like them both being available. Not such a problem until some of the other features start working since I dont use both. But obviously when that bit does start going I'd like to use both cards.