FiOS setup configuration with PVRX2

[Kid_Ego5150]

I've had my system working with PVRX2 and FiOS before but due to an intersting story involving a house flood I've just now started to re-setup my htpc in my theater room after it being dismantled for 5 months and have run into a problem. I can only view one channel in live TV (channel 3) via the FiOS STB (Motorolla QIP2500-3). Whenever I change the channel in PVRX2, the blaster sends the correct info to the STB to change channels but all I get is static. I do however get the correct audio for the channel though. The weird part is that if I change the channel back to channel 3 the static goes away and is replaced with the video for the channel I'm now leaving just before it switches to the next channel. Am I missing a config point or a setup feature somewhere that I just don't remember? I'm running fresh install of v1.4.7 onto a Hauppage PVR150. FiOS set up is coax from the wall to STB and coax out to PVR. EPG is fully updated too. Thanks for suggestions and help.

[nightwalker]

I had this happen during my initial setup as well. It turned out to be a setting under the capture sources. I had chosen Fixed channel tuner instead of composite channel or svideo tuner, which ever you use from your STB.

I can't say for sure that's you're problem but it's worth a look.

[Kid_Ego5150]

That's exactly what it was actually. Changed that and everything is good again. Thanks.

[nightwalker]

Silly thing like that drove me crazy for days, doncha just hate that.