2006-10-01, 02:06 AM
Hi,
First of all, Thankyou to the developers and support community for this excellent application.
I recently have (eventually successfully) installed a Leadtek DVT2000 H, however had a lot of difficulty getting the BDA drivers to be recognised and work.
The previously described BDA.ini files did not work for my card (?) so I needed to edit the BDA.ini files according to the WIKI guide and using graphedit.
There i found my BDA filter names to be different to those shown previously for this card, so I editted the ini, but still no success.
After thinking about it all, and repeating the procedure ad nauseum, I realised the instructions in the WIKI have a statement which should be reversed:
"Use the filter specified in BDA Receiver Component as the name for FILTER_TUNER. Use the filter specified in BDA Source Filters for FILTER_CAPTURE Spelling must be exact, including capitals."
As far as I can determine, this should read
"Use the filter specified in BDA Receiver Component as the name for FILTER_CAPTURE. Use the filter specified in BDA Source Filters for FILTER_TUNER Spelling must be exact, including capitals."
Once I swapped these around in my ini, the card was recognised and off I went.
Hopes this helps someone wrestling with a card!
First of all, Thankyou to the developers and support community for this excellent application.
I recently have (eventually successfully) installed a Leadtek DVT2000 H, however had a lot of difficulty getting the BDA drivers to be recognised and work.
The previously described BDA.ini files did not work for my card (?) so I needed to edit the BDA.ini files according to the WIKI guide and using graphedit.
There i found my BDA filter names to be different to those shown previously for this card, so I editted the ini, but still no success.
After thinking about it all, and repeating the procedure ad nauseum, I realised the instructions in the WIKI have a statement which should be reversed:
"Use the filter specified in BDA Receiver Component as the name for FILTER_TUNER. Use the filter specified in BDA Source Filters for FILTER_CAPTURE Spelling must be exact, including capitals."
As far as I can determine, this should read
"Use the filter specified in BDA Receiver Component as the name for FILTER_CAPTURE. Use the filter specified in BDA Source Filters for FILTER_TUNER Spelling must be exact, including capitals."
Once I swapped these around in my ini, the card was recognised and off I went.
Hopes this helps someone wrestling with a card!