Problem with HVR-1600

[bigbus01]

Sub,

I installed an HVR-1600 the other day and it was working well. Today it recorded a show and it came out fine. All of a sudden the analog side stopped recording, stopped working on Live-TV, etc. When a recording starts or I try to watch a show (even on a client), the green G shows and the status is it is recording. It creates a folder but there is no file in it. The hard drive is flashing like it is recording.

Any ideas?

Thanks,

Bigbus

[sub]

21:31:36.140 ERROR failed to start Conexant Graph
21:31:36.140 VERBOSE ERROR_DEVICE_NOT_CONNECTED

This will be the error, but its not clear what the cause of this is. Are you sure the device wasnt in use by something else on the machine?

[sub]

I thinking maybe the card names in bda.ini and direct.ini need to be renamed to match. This would stop GB-PVR from trying to use the analog and digital side of this at the same time.

[bigbus01]

The digital side is working but the analog side is not. I can watch and record digital.

[sub]

and you're sure its not trying to use the analog and digital side at the same time?

[bigbus01]

I don't think so. I'm looking at the two files in the 1600 section and I don't know what you mean about the names.

When I start the analog side, it is tuning the cable box. When I run Digital, it doesn't so I would assume it isn't using them at the same time.

Yesterday I got it to record off both tuners so they can work at the same time--I don't think that is what you mean.

[sub]

Yesterday I got it to record off both tuners so they can work at the same time

Ok, it must physically have two tuners.

I'm not really sure.

[bigbus01]

Here are the two files. Does this help? I don't see where the names would be a problem.

Thanks for the quick replies.

Bigbus

[sub]

If its got two separate tuners, then this wont be the cause of your problem.

What I was suggesting though, was that it should be [Hauppauge HVR-1600] in both these files so that GB-PVR would be able to work out both capture sources were the same device, and shouldnt attempt to use them at the same time.

[bigbus01]

Could it be that I set up two inputs on the analog side as two separate capture sources. I am using the S input as the primary but I also setup the cable input using the same device number for live-tv. Should I call that one capture source number 2?