1.4.7 and multidec - no go

[kylebrophy]

Hi,

I upgrade my 1.3.11 to 1.4.7 last night.

the previously working multidec setup no longer worked after the upgrade (there were no issues as such during the upgrade) - completed without issue.
all the multidec settings on misc2 tab were as in 1.3.11 - so nothing had been turned off along the way.

I also tried a rescan of the C1 satellite - and it came back to me telling it had found no channels. I know i have enough signal - but for some reason it didnt find any channels after rescan (it displayed the C1 info channel page prior to rescan - proving there was signal).

I have rolled back to 1.3.11 where multidec is working perfectly once again.

EDIT - have read that multidec settings are now controlled via the capture source - rather than the misc2 tab. May have another crack at this in a few days.

[sub]

EDIT - have read that multidec settings are now controlled via the capture source - rather than the misc2 tab. May have another crack at this in a few days.

Yep, you need to edit your capture source to set it use multidec.

Its on a per-capture source basis now rather than the old global setting which was removed from the Misc2 tab.

[kylebrophy]

Yep, you need to edit your capture source to set it use multidec.

Its on a per-capture source basis now rather than the old global setting which was removed from the Misc2 tab.

had another go to V1.4.7 last night.
Changed the CI Settings at the capture source

ALL GOOOOOD !!!!

YAY

another successful upgrade.

[DanielP]

Thanks for pointing out the multidec changes. I was also wondering why this had stopped working and there was no option to enable multidec in the usual place!!

Daniel