Problem reconfiguring T-500 card

[ErikW]

I am running an older version 99.12 on one of my pcs for compability with PVR350 TV-Out. As Denmark have changed digital TV i was just planning to rescan the channels to get the new ones.

I had problems with that so i cleared the configuration and started from scratch. Deleted GBPVR folder and reinstalled 99.12. But each time i get to scan for channels i get "the capture source needs to be saved first. Save capture source first OK/Cancel". clicking OK i get the error "you must setup the recording source first".

I have checked the filtercheck and bda.ini, but as i can see the cards correctly the i assume that there is nothing wrong here.

However i have found in the config.exe-native gives some "filter"-errors that i do not understand.

This have worked for about 1-2 years. Please advise what i should look for.

Hauppauge wintv7 works fine and can find and show all the available uncoded channels.
That indicates to me that the T-500 drivers are loaded correctly, but i need help to find a workaround to get the new channels configured in GBPVR.

I know that its an old version, but i hope that some can help