I was wondering if any one had some advice on tracking down why my computer hard-locks (screen stuck, no mouse, etc), occassionally while i'm recording.
There is no event log that shows it dieing. Its normal right up to the time it dies, then resumes right there on restart.
I ran the microsoft ram test cd on the computer a number of months ago, and it was ok. I am going to put it back on again, and let it run for a day or two.
The computer is fine most of the time. It doesn't lock when i'm watching videos, etc. This morning, a recording started at 8:00, and it was hardlocked at 8:14. Yesterday, it recorded 3 hours of TV with out a hitch..
I have downloaded and installed 'Community3x.exe' and 'SkinPlugin3.2.2.Setup.exe'
I have the new skin working as default in PVRX2 (and it looks great!)
When I launch the config utility, on the plugin tab I see 'Skin' is checked - but do not see any options to be able to configure it. I am missing something?
Since my harddisk completly chokes if a postprocessing runs concurrent with a recording I have installed Zehdâs PostProcessing.bat with deferred Transcoding and have it run late when no recordings normally occur. Works great except for one problem:
While transcoding, the second of two back-to-back recordings always comes out with a 25-27 seconds total length .avi file (the original .mpeg file is ok)
At first I suspected that it was because gbpvr would use the second capture device since it's first choice was busy, so I swapped the order of the cards in config-app, but strangly the result is the same!
I'v attached the files that might give a clue of what's going on.
Does anybody have a solution?
To override the 'run in windowed mode' that is in the config.xml.
This would be handy when using graphedit (or graphsource) to fiddle with the filters to avoid the need to change it to 'windowed' first then back to 'fullscreen' afterwards. (or is there a key to do that?)
Hi,
This is a great plugin - adds some very desirable features.
Here's a couple more I would like too-
1) Some way to keep the sort the same for the folders (I dont mind how - I only use one setting)
2) This may be one better addressed by gbpvr itself, but I'll mention it here anyway just in case. Playing back .ts files in 'videos lib' (with gbpvr 1.3.11) uses the built-in ts file reader. I would like to able to use the default directshow one as some of my ts files dont work with gbpvr. Is this under the control of this plugin or gbpvr itself?
i really need a help with my new helius mvp that i buy from ebay. When i turn on the device its just stay in the orange screen with "helius" in the middle. So if one of you guys can really help with this i will realy appreciate. I dont know nothing about mediastreaming but if you talk the technical language , i will understand.
I just started again with GBPVR after 2 years, back then I was reliant on XRecord to easily view my recordings.
Now, after installing the latest (1.3.11) and installing XSuite (0.50), I get an exception error (see image).
The only difference from my previous installs was that I installed GBPVR in a different drive (D:\) because I am using SteadyState on my C:\ drive to protect it. I had to move GBPVR to another drive (reinstalled).
My question, could the different drives be important to XSuite, is it hardcoded to the c:\ drive?
In any case, since this is a fresh install, only XSuite is the only non-default plugin.
