Problem with new release V0.019

[kb0teo]

Sub:

I have a problem with the newest release V0.019. I uninstalled the V0.018L. And installed the new version. As recommended.

My problem is that the USB URIT setting on the configuration program of V0.019 do not seem to be working correctly. I set a new definition for my DirecTV remote using the USB-UIRT CHANNEL CHANGER CONFIGURATION menu. The only new change I noted was the addition of the "OK" or "ENTER" after you were prompted the numbers 1 thru 0 which I entered and then named DirecTV. I chose not to check any of the options Zero pad channel, Send ENTER/OK after transmission, or Use three digit channel numbers. This setting worked fine with V0.018L and would change the channels on my DirecTV receiver and allow the GR-PVR to record the correct programs.

But on the new release V0.0.19 it seems to change the channel only one time then stop. I can record the first program schedule to be recorded the recording scheduled after that will not change the channel setting on my DirecTV receiver. The USB URIT will flash like it is sending the signal but the channel stays the same. I also tried to use the manual record to see if the channel changer would work but no luck there it will not change the channel but will flash like it is sending a signal. At first I thought it was a problem with my USB URIT or the driver for the USB URIT so I uninstalled my driver thru the DEVICE MANAGER in WinXP. Then plugged the USB URIT back in and installed the driver again. I also went in to the GR-PVR Configuration menu and went to USB-UIRT CHANNEL CHANGER CONFIGURATION and was going to create a new definition for DirecTV receiver I click on the NEW to config a new definition.

Here I believe is the problem when I do that now the window comes up and you are to enter the numbers the program will cyclic though all the numbers and the enter key or OK with out me pushing the keys on my remote then it is prompting me for then ask me for a name for my new profile.

I tried several time the its the same the Prompts are displayed and ask you to press a key number and it says to release number and going to the next all with out me pressing any keys at all! It act as the program is stuck in a loop. Then asks for a name for your new profile!

The USB URIT worked fine in the V0.018l and can reinstall it so I can record programs. But I really like you new V0.019 and the fast forward and reverse works for me in this release.

Hopefully this is a minor bug?

[kb0teo]

   

Sub:

Well after much installing and uninstalling of the usb-uirt drivers and the GB program.  I finally got it to change the channels on my DirecTV correctly and was able to create a workable definition for DirecTV.

What it was I do not know!  I only know that my PC (Personal Confuser)  got the best of me again!

But I am really pleased with your new release.

Thanks for the program.

     

[sub]

Good to hear you got it going. One less thing for me to look at...