HVR1300 problem with v0.97.7

[mangroa]

I've uninstalled the old version of GBPVR and even deleted the old gbpvr dir so its a completly clean install after installing .Net2.0.

Configuring from scratch I cannot get any analogue tv channels via my HVR1300. I select Hauppage Roslyn for the card. This used to work on the previous version.

It lets me configure them, but when I try to view them using gbpvr I get a black screen and have to kill the process!

Freeview channels will configure correctly. I need the analogue channels as I cannot receive all Freeview channels and use Analogue for ITV and C4.

I'm uk based.

Any ideas????
Thanks
Alan

[sub]

Reproduce the problem, then zip and attach the logs and I'll take a look.

[fuzzweed]

have you tried 'Hauppauge HVR1300 (analogue)' rather than Rosalyn?

[mangroa]

Ok, I've ziped the logs.

Seems to be logging...
"10:52:08.156 VERBOSE GetFilterProperty - IKsPropertySet->QuerySupported property failed" in and endless loop. Log file grows rapidly.

I've tried with Roslyn and HVR1300(Analogue)

[fuzzweed]

OK, so it turns out that I have this exact problem after all. The composite input works fine, and I usually watch that and DVBT, so I hadn't realised the problem with the internal tuner channels.

Black screen, the HDD starts chugging away, 100% CPU usage by GBPVR and a 39Meg logfile whaich I can't upload, but the just of it is the same (VERBOSE GetFilterProperty - IKsPropertySet->QuerySupported property failed" )

Tried overlay, VMR9 and FFDSHOW disabled. (and Rosalyn and HVR(analogue) devices )[ATTACHMENT NOT FOUND]

[sub]

You could try editing the roslyn section in direct.ini, and setting INIT_MODE=ECP or INIT_MODE=DEFAULT. You'll need to check if either of these generate errors in the logs.

[fuzzweed]

tried setting INIT_MODE=ECP and Default - same problem with roslyn and HVR(analogue) though.

[sub]

Are you saying it still has the "IKsPropertySet->QuerySupported property" error message? If so, then you didnt set it correctly. INIT_MODE=DEFAULT will not make these calls.

[fuzzweed]

[Hauppauge HVR-1300 (analog)]
INIT_MODE=DEFAULT

[Hauppauge Roslyn]
INIT_MODE=DEFAULT

10:06:59.235 VERBOSE GetFilterProperty - IKsPropertySet->QuerySupported property failed


[ATTACHMENT NOT FOUND]

[dfdario]

Have you tried newer drivers from Hauppauge?
http://hauppauge.lightpath.net/de/chelse...-24111.exe
The setup install also a patch to Windows XP. I dont know if it could solve your problem but it solved mine (I wasn't able to tune up DVB-T on both my HVR-1100 and HVR-1300 after 97.7 installation).

Good luck