Playback won't resume after Pause.

[sub]

Try increasing the 'live tv pre-play delay' setting in the config app playback tab. Start with 4 seconds to test it out.

[drlava]

That did stop it from exiting to the guide, but now I get a black screen. With either decoder they both still fail to resume after pause.

[drlava]

Ok, I found some settings that make it work:
-Overlay renderer
-System default Video and Audio decoders (is there a way to tell what this is?)
-1000ms live buffer
-enable multi-record support OFF (live channel change doesn't work with it on)

I wish the EVR worked as it did in the previous version, but for now these settings are usable (until some other install process changes what 'system default' points to.)

[sub]

I'm sure its just decoder related, and should work with EVR, so keep experimenting.

[drlava]

Any ideas why the decoder would have worked with the previous GBPVR version but not this one?

[sub]

No, but I'm not aware of any other reports of it, so it makes me think something else has probably changed on your machine too.

[maxharp3r]

I experienced the same problem as the poster (GBPVR 1.3.11). The problem is independent of the video decoder (broken on both Nvidia and InterVideo). While I am able to pause TV using the EVR renderer, system performance is unacceptably slow.

Solution:
To pause TV using a VMR9 renderer, uncheck "Enable Multi-Record Support" under the Misc 2 tab.

Happy tv timeshifting,

Max

[sub]

Solution:
To pause TV using a VMR9 renderer, uncheck "Enable Multi-Record Support" under the Misc 2 tab.

This sounds like you havent installed the patches from the '1.3.11 survival guide' thread.

[maxharp3r]

This sounds like you havent installed the patches from the '1.3.11 survival guide' thread.

No, and I won't, since this patch appears to just apply to folks with >1 tuners.

Aforementioned "survival guide": http://forums.nextpvr.com/showthread.php?t=40303

Max

[sub]

Actually, it doent say >1 tuner. It just says "anyone using digital capture devices with multi-record enabled". This is also for for people with one tuner.

:mad:

I'm not hassling you - it just sounded like something that would have been fixed by that patch.