Wintv-CI don't works with 1.4.7

[sakamotodj]

Hi,
I tried to test wintv-ci with new gbpvr but doesn't work.
attached there is log file.
i think the problem is here
2009-09-03 18:31:13.656 VERBOSE FindFilterByName failed to locate filter: WinTVCIUSBBDA Source
2009-09-03 18:31:13.656 VERBOSE Unable to load 'WinTVCIUSBBDA Source'. WinTV CI support disabled.

Somebody knows if is necessary to install win-tv cam menu utility?

[sub]

2009-09-03 18:31:13.656 VERBOSE FindFilterByName failed to locate filter: WinTVCIUSBBDA Source
2009-09-03 18:31:13.656 VERBOSE Unable to load 'WinTVCIUSBBDA Source'. WinTV CI support disabled.

That sounds like you dont have the WinTV CI drivers installed.

If you're sure you do have them installed, can you run filtercheck.exe from the GBPVR directory, then post the filtercheck.log that gets created.

Somebody knows if is necessary to install win-tv cam menu utility?

I dont think you need it unless you need to access the CAM menu.

[sakamotodj]

That sounds like you dont have the WinTV CI drivers installed.

If you're sure you do have them installed, can you run filtercheck.exe from the GBPVR directory, then post the filtercheck.log that gets created.

I dont think you need it unless you need to access the CAM menu.

this is filtercheck.log

[sub]

Hmm, that filtercheck.log doesnt seem to tally up with your previous logs.

Can you try viewing live tv again, then repost the pvrx2.exe.log and pvrx2.exe-native.log?

[sakamotodj]

Hmm, that filtercheck.log doesnt seem to tally up with your previous logs.

Can you try viewing live tv again, then repost the pvrx2.exe.log and pvrx2.exe-native.log?

yes is correct filter check was run after gbpvr reinstall.

Now when i try to map chennel after set the common interface on the recording source.setting.common interface the program show me this message box " GBPVR was unable to start the BDA Device you have configured...."

but the drivers are installed you can see on the attached image

[sub]

Can you try viewing live tv again, then repost the pvrx2.exe.log and pvrx2.exe-native.log?

[sakamotodj]

Can you try viewing live tv again, then repost the pvrx2.exe.log and pvrx2.exe-native.log?

Sorry, but it's impossible to map channel's with ci enable because the program show me the message box " GBPVR was unable to start the BDA Device you have configured...."

Help me please

[sub]

Post the config.exe.log and config.exe-native.log and I'll take a look.

[sakamotodj]

Post the config.exe.log and config.exe-native.log and I'll take a look.

Attached there are compressed log files

[sub]

Sorry, but that log shows no attempt to use the capture device or WinTV-CI. You'd need to post those logs after clicking the 'map digital channels to epg channels' button and seeing the error.