I am trying to configure this source.
I can get the analogue going, but no digital.
I update my epg, scan the channels and then map.
When i go to play, it tries to display but it can't .
I get a message that says "no signal detected".
That's BS, I have loads of signal. It also found the channels when it scanned.
Not sure where to look but would appreciate some help.
Currently I have configured as a digital source only on a fresh install in XP SP3.
I have Comskip configured to run after each program is recorded and GBPVR to automatically skip past commercials when playing back recorded programs.
Occasionally, Comskip will incorrectly mark program material as commercials so during playback it is skipped over. Currently, the only way to be able to see that portion of the program is to stop playing back the recording, run CONFIG (assuming that no programs are being recorded at the time) and uncheck "Auto Skip Commercials" on the Misc Tab, and then go back to PVRX2 to watch the recording, and then after watching the program go back to CONFIG and set the Auto SKip Commercials parameter.
It would be nice to be able to disable this parameter setting during playback so if, when playing back a recording it is apparent that Comskip was overly aggressive in its processing, the user could click on an option to not skip commercials during the playback of the current recording but still be in effect for any subsequent recorded programs you watch.
Is there a way to record just the audio from a station? The video on these channels is just a black screen, or static image saying the current track. I would hate to waste the space to record this video, when I just want the audio.
Hi
I am trying to get both analogue and digital working with a Hauppauge HVR-950Q.
If i set the source as an analogue device I can get the analogue channels running. To bring in the digital, do I add another source set it to digital and call it device 2 yet point to the same hardware.
I just bought my son an EGreat NMT and a WD 1TB black drive and I was looking for a case to put the hd in and I ran across some silicon hard drive protectors - they look pretty good and are CHEAP! (check fleaBay)
I ordered one for my son's setup, I'll report back what we think of it once it gets here and we use it for a bit.
I've just made the cut over to the Comcast digital signal and now have DTAs (digital transport adapters) to contend with. I've read other postings and I didn't see anything that appeared (with my limited knowledge) to address my issue.
I'm using a Hauppauge HVR 1950 with Media MVP along with GBPVR version 1.0.16. The primary issue is that the feed from the Comcast tuner (DTA) into the HVR 1950 only shows as one channel on both the WinTv and GBPVR side. Only the Comcast remote control can change to a different channel. I've changed configuration settings in GBPVR's "Capture Sources" and "Recording Sources" to "Fixed channel" and set that channel to 3 but now that's the only station that is referenced across the board.
The question then is what settings allow for the HVR 1950 to change the channel on the Comcast tuner (DTA)? Are these settings on the Hauppauge side of can this be accomplished in GBPVR? Or is the situation worse then I'm able to see?
(check fleaBay)